Elaya kumar k posted a status
Apr 4, 2017
hi!. i had manually calculated infiltration rate . if i apply the same value into SWMM will it be the same infiltration rate or not?...

You need to be a member of SWMM Historical Knowledge Hub – models, code, and discussions. to add comments!

Join SWMM Historical Knowledge Hub – models, code, and discussions.

Comments

  • Robert Dickinson April 4, 2017 at 1:57pm
    If you use Horton infiltration and set the maximum and minimum infiltration rate to your calculated value then it will be the same. You have the have the minimum smaller than the maximum but the difference can be very small
This reply was deleted.