All Forums

Pollutant to a node

Posted by Upaka on March 16, 2010 at 9:47am in Water Quality

Hi,

Is it possible to add a pollutant concentration (eg. TSS = 20 mg/L) to a node at a network in SWMM?

Thanks a lot

You need to be a member of SWMM 5 or SWMM or EPASWMM and SWMM5 in ICM_SWMM to add comments!

Join SWMM 5 or SWMM or EPASWMM and SWMM5 in ICM_SWMM

Email me when people reply –

Replies

Robert Dickinson March 16, 2010 at 9:49am

Yes, you can add a Dry weather flow concentration to a node in SWMM 5. 1st you make a pollutant, then go to a node and add DWF and a pollutant concentration. The load - flow * concentration will go into the network.
- Robert Dickinson > Robert Dickinson March 16, 2010 at 9:53am
  
  Here is a sample SWMM 5 model for you to look at - it has one TSS pollutant and one loading point - the node 8040
  - Upaka > Robert Dickinson March 16, 2010 at 9:58am
    
    Hi,
    Thanks a lot and I will be working on it.
    Thanks again for your effort.
    Upaka

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use SWMM 5 or SWMM or EPASWMM and SWMM5 in ICM_SWMM.

Please check your browser settings or contact your system administrator.