All Forums

editing subcatchment, node and conduit parameters using swmm5 interface commands

Posted by yasert on March 5, 2013 at 1:30pm in MATLAB and Batch SWMM5

Hi there,

I am going to edit some parameters in swmm5 input file through swmm5 interface commands.

Is it possible to do that or not?

I can find some commands to read results for example GetSingleResult to view simulation results for particular parameters but I can not find any commands to change some particular parameters as an new input file.

I think this can be done for Epanet2 through epanet toolkit. 

Please tell me if it is possible to change input file parameters (for example channel dimensions) through SWMM5 interface.

thanks in advance. 

You need to be a member of SWMM 5 or SWMM or EPASWMM and SWMM5 in ICM_SWMM to add comments!

Join SWMM 5 or SWMM or EPASWMM and SWMM5 in ICM_SWMM

Email me when people reply –
Follow

Replies

  • yasert March 5, 2013 at 1:42pm

    thank you Robert.

  • Robert Dickinson March 5, 2013 at 1:38pm

    Hi, I thought we discussed this in the past, you need to parse the input file in Matlab.  SWMM 5 does not have a toolkit as in EPANET 

This reply was deleted.