All Forums

Subject:  Steps in Using RDII Analyst for InfoSWMM, ICM and InfoSewer

Step 1: Create a Base UH  in the Operation Tab of the Attribute Browser using RDII Analyst (Figure 1)

Step 2: Assign a UH to at Least 1 Node Using the Inflow Icon  

Step 3: Open Up RDII Analyst and Click on New to Create a RDII Session    

Step 4: Define the Flow and Rainfall File     

Step 5: Review the Imported Flow Time Series Step 6: Review the Imported Rainfall  Time Series          

Step 7: Units and RDII Analyst Dates are Controlled by the Simulation Manager   

Step 8: Extract DWF from the Flow Time Series    

Step 9: Assign a UH to at Least 1 Node Using the Inflow Icon  

Step 10: View the DWF Pattern         

Step 11: Create the RDII Time Series          

Step 12: View the RDII Time Series   

Step 13: Run Once Feature to See how Good the Current RTK Parameters are in matching the monitored flow

Step 14: You can use Graph Control to show the mean of the Observed and Predicted RDII on one Graph.        

Step 15: Calibrate the RTK Parameters        

Step 16: Run the GA 

Step 17: Assign the Intermediate Answers  to the UH     

Step 18: View the Calibration Graph  

Step 19: Event Identification   

Step 20: Assign the Found DWF Pattern     

Step 21: Node DWF and RDII Inflow

Step 22: 3 RDII UH’s Used in the Simulation of the RDII Flows